Simrad: Rf300 Installation Manual

Simrad kept it simple here. The RF300 typically uses a two-wire frequency interface. Green/White:

Once physically installed, you must configure the autopilot software to recognize the unit. Installation manual simrad rf300 installation manual

Once installed, you must perform a "Dockside Setup" via your autopilot controller (e.g., AP24, AP28, or an MFD like the Simrad NSS/NSO). Source Selection : Navigate to Settings > Network > Sources and ensure the is selected as the primary rudder feedback source. Rudder Calibration Rudder Calibration from the installation menu. Follow the on-screen prompts to center the rudder. Simrad kept it simple here

transmitter lever until it aligns with the center position mark, located opposite the cable entry. : The center of the must be in line with the center of the rudder post. Transmission Arm : Ensure the Y1cap Y sub 1 dimension (rudder tiller arm) is equal to the Y2cap Y sub 2 dimension (RF300 lever) to maintain linear feedback. Installation manual Once installed, you must perform a

Position the unit so the feedback arm is as close to parallel with the rudder arm as possible when the rudder is amidships. If the geometry is off, your autopilot will get "confused" by non-linear readings. 2. Making the Connection

| Pin | Wire Color | Signal | |-----|------------|------------| | 1 | Shield | Drain | | 2 | Red | +12V DC | | 3 | Black | Ground | | 4 | White | CAN High (H) | | 5 | Blue | CAN Low (L) |