Alcor | Micro Au6989sn-gtc Software

If you are attempting to repair a drive with this controller, follow these general steps: Identify the Chip: Use a diagnostic tool like ChipGenius to confirm the Controller Part-Number is exactly AU6989SN-GTC. Download the Tool: Locate the specific version of AlcorMP that supports your Flash ID code (e.g., Samsung, Toshiba, or SanDisk IDs). Run as Administrator:

Using the wrong version can brick your drive. Always confirm your chip ID and flash type before proceeding. alcor micro au6989sn-gtc software

To manage or repair drives using this controller, you must use the specific version of Alcor MP (Mass Production) tools that support the revision. Using the wrong version can lead to the drive not being detected or further corruption. Recommended Tools If you are attempting to repair a drive

If you’ve plugged in your flash drive only to find it "Write Protected," showing "No Media," or refusing to format, you aren't alone. These issues are common with USB drives using the controller. Always confirm your chip ID and flash type before proceeding

Used to fix "write-protected" errors, "disk not recognized" issues, or to restore the drive to factory settings after a firmware corruption. Version Compatibility:

| Error Code | Meaning | Solution | |------------|---------|----------| | | NAND not supported | Try newer AlcorMP version or manually select NAND type. | | 0x02 | Bad block count too high | NAND is failing – tool will likely fail; discard drive. | | 0x03 | Firmware mismatch | Extract firmware (.fw or .bin) from another drive or find correct firmware pack. | | 0x06 | CID write fail | Reinstall driver, disable signature enforcement, run as admin. | | 0x0E | Timeout during test | Drive connection unstable – try different USB port (USB 2.0 preferred). |