Crawford CDM9 950 installation requires precise mechanical alignment and electronic configuration to ensure safe operation of industrial overhead doors. Hurð ehf. Mechanical Installation Steps
Fit the second stop ring and mount the torque bar onto the mechanical unit. Install the rubber damper between the torque bar and the console. Placement Height: crawford cdm9 950 installation manual
, including critical jumper settings (e.g., X2 and X3) and lid contacts (X4 and X5). Commissioning and Calibration Install the rubber damper between the torque bar
The installation and technical documentation for the Crawford CDM9 950 : Squeeze the rubber seal to verify that
Before powering up, manually disengage the door and position it roughly 1.5 meters above the ground.
: Squeeze the rubber seal to verify that the safety LEDs (D4 and D5) respond correctly. The door should then be run through a full cycle to confirm it reverses correctly upon reaching the floor. Hurð ehf. Technical Specifications Specification Max Door Weight Up to 400 kg (Standard CDM9) or 800 kg (CDM9 HD) Opening Speed 0.25 m/s (Standard CDM9) Supply Voltage 230 V AC, single-phase, 50/60 Hz Protection Class IP55 for the main unit Dimensions 340 x 230 x 140 mm